NEC SigmaBlade B140a-T Betriebsanweisung PDF herunterladen (Seite 334)

B-36 Installing the Operating System

Setup Teaming

When the system is Windows Server 2008 64-bit (x64) Editions / 2008 32-bit (x86)

Editions

IMPORTANT:

 Teaming is not supported with Windows Server Core.

 AFT/ALB setting must be done after System Update completed.

1. Open the [Device Manager].

2. Open [Network adapters] → [Intel(R)xxx] properties.

3. Click [Teaming] tab and check the [Team this adapter with other adapters] check box.

Click [New Team].

4. Fill the name of the team in [Specify a name for the team] and click [Next].

5. Include the adapter to the team and click [next].

IMPORTANT: Do not include the member adapter over than two.

6. Select a team type ([Adapter Fault Tolerance]/[Adaptive Load Balancing]).

Click [next].

7. Click [Finish].

8. Click [TEAM:"Team name"] from [Device manager]->[Network adapters] to modify the

team.

Click [Settings] tab and click [Modify Team] button.

9. Refer to the following procedure to set the team member adapter priority status.

– Set Primary

Point the adapter and click [Set Primary] button.

– Set Secondary

Point the adapter and click [Set Secondary] button.

NOTE: Adapter priority config can be confirmed by the following

procedure

1. Click [TEAM:"Team name"] from [Device manager]->[Network

adapters].

2. Click [Settings] and confirm Adapters in team list.

10. Click [Test Switch]->[Run test] to confirm the adapter team is properly setup.

Confirm the result in [Test results]

11. Reboot the system.

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 375 376

Keine Kommentare

NEC SigmaBlade B140a-T Betriebsanweisung Seite 334