NEC GammaCompMD QA Bedienungsanleitung PDF herunterladen (Seite 78)

GammaCompMD QA Client User Manual

NOTE:

For scheduled execution or test from the network, the display sensor is used

regardless of the sensor selection. When a display sensor is used with a wide format

display, be sure to set the EXPANSION mode to “FULL” in the OSD of the display.

Figure 55: Preferred Sensor Selection Listbox

Display Sensor Selection

If a display with integrated front sensor is selected, the model name

of the display is shown. If the selected display does not have a front

sensor, “MD-N2M5B” is shown. To select Display Sensor as the

Preferred Sensor, it is necessary to select a serial number for the

retractable sensor model MD-N2M5B to be used for this display.

NOTE: The following Serial Number Selection Dialog box will only be shown, if a retractable

sensor model MD-N2M5B is actually connected to the system. Otherwise, only the message

“no sensor” is visible.

Serial Number Selection

It is possible to select the serial number of the retractable sensor

in use. If a certain serial number has already been used for a

different display, and the OK or Apply button is clicked, the last

setting becomes effective, and then this retractable sensor is no

longer set up for the previously specified display.

Test MD-N2M5B Sensor button

This starts a test by swinging the arm of the MD-N2M5B sensor out

and back in. After selecting the serial number from the Serial

Number Selection listbox, click the MD-N2M5B Sensor Test button

to check the operation of the MD-N2M5B sensor assigned to the

selected display. If a serial number has not been selected, it is not

possible to click the Test MD-N2M5B Sensor button.

Reference Calibration button

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 181 182

Keine Kommentare

NEC GammaCompMD QA Bedienungsanleitung Seite 78