NEC GammaCompMD QA Bedienungsanleitung PDF herunterladen (Seite 113)

GammaCompMD QA Client User Manual

・ Test Connection button

After the data below Connect to server set up in the Event Logger Server Setup dialog box

and confirmed with OK, the Initialize System Configuration dialog box, as shown Figure 92

returns. Click on the Start button to start the System Service. After the system service is

running, the Test Connection button is used to confirm the communication with the Event

Logger Server part of the GammaCompMD QA Server. The button cannot be clicked if

Disconnect from Server is selected or if no address has been entered.

NOTE: If the connection test was successful a success message will be shown. If the

connection test is not successful, please wait at least for two minutes until the connection

test times out and returns with an error message.

NOTE: All Port address (number) settings, as shown in Figure 95, were initially defined during

installation of GammaCompMD QA Client.

Restore Backup Data Restores history data, which was either:

Backed up during a scheduled backup or A database backup during

un-installation of GammaCompMD QA Client.

When Restore Backup Data is clicked, the Select a backup file to

be restored dialog box, as shown in Figure 96, is displayed.

Figure 96: Select a backup file to be restored dialog box

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 181 182

Keine Kommentare

NEC GammaCompMD QA Bedienungsanleitung Seite 113