NEC GammaCompMD QA Bedienungsanleitung PDF herunterladen (Seite 140)

GammaCompMD QA Client User Manual

Source display selection The source display can be selected with the radio button above the

display number. Only one unit can be selected as the source

display.

Target display selection The target display can be selected with the check box above the

display number. Multiple target displays can be selected. You

cannot select a target display if a source display has not been

selected.

Cancel button Closes the dialog box and cancels Display Matching.

OK button Start Display Matching with the OK button. If the Calibration Setup

dialog is displayed, it will automatically close when display

matching starts. You can only click on OK if the source display and

at least one target display are selected and the Operator Name is

entered.

NOTE:

・If you are using a sensor without color support or the target display is a grayscale display,

the color temperature cannot be adjusted.

・If the interface mode for both the source display and the target display is set as NAVDisplay,

the displays are not selectable. If the interface mode is set to StdDisplay for the target

display, this display is also not selectable.

・After all measurements on the source display have completed, all calibration parameters of

the source display will be used to calibrate the target display(s). The calibration will not

return to the previous parameters, if the calibration of the target display is cancelled or

interrupted.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 181 182

Keine Kommentare

NEC GammaCompMD QA Bedienungsanleitung Seite 140