NEC Express5800/320Ma Bedienungsanleitung PDF herunterladen (Seite 77)

Removing and Inserting a SATA Disk Drive

CRU Replacement Procedures 5-31

Removing and Inserting a SATA Disk Drive

Each CPU- I ⁄ O enclosure contains three SATA disk drives, which are located on the

front panel of the enclosure. You can remove these drives to replace them or to perform

other maintenance procedures.

Estimated time: One minute for each disk.

Tools: None.

NOTE

Anytime you remove more than one SATA disk drive at a

time, label the drives on the bezel of each drive to ensure

that you can replace them in the proper order. The

numerical slot designation for each disk is noted on the

front of the SATA drive bay.

1. Remove the bezel. See “Removing and Replacing the Bezel” on page 5-3.

2. Press the green release button on the latch on the front of the disk drive, pull the

latch, and remove the disk drive as shown in Figure 5-20.

CAUTION

If the status LED for a disk drive is blinking amber, do not

remove the drive (see “SATA Disk-Drive LED” on

page 3-5).

CAUTION

Do not pull the drive, use the latch.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 109 110

Keine Kommentare

NEC Express5800/320Ma Bedienungsanleitung Seite 77