NEC Express5800/320Ma Bedienungsanleitung PDF herunterladen (Seite 64)

Replacing or Installing a PCI Adapter

5-18 Express5800/320Ma: Operation and Maintenance Guide

Replacing or Installing a PCI Adapter

NOTES

1. The PCI slots are physically labeled 1-3 (Figure 5-9)

on the enclosure chassis. (Your system might contain

only slot 1). The ftServer Management Console

(ftSMC) interface displays these PCI slots as PCI Slot

Info - 9, 10, and 11.

2. No slots are reserved.

3. PCI slots 2 and 3, when present, are located on a PCI

riser assembly inside the CPU- I ⁄ O enclosure. While

performing the procedures to install or remove these

PCI adapters, you must remove the PCI riser

assembly as described in “Removing and Replacing

the PCI Riser Assembly” on page 5-26.

4. Install full-height and extra-long PCI adapters only in

PCI slot 2 or 3.

5. For information about replacing an Ethernet PCI

adapter that is part of an Ethernet fault-tolerant team,

also see the Express5800/320Ma: PCI Adapter

Guide.

Figure 5-9. PCI Slot Locations

To replace a PCI adapter, remove the PCI adapter from the CPU- I ⁄ O enclosure

enclosure and install the replacement adapter.

1 Slot 1, low profile (PCI Slot Info - 9 in ftSMC)

2 Slot 2, full height (PCI Slot Info - 10)

3 Slot 3, full height (PCI Slot Info - 11)

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 109 110

Keine Kommentare

NEC Express5800/320Ma Bedienungsanleitung Seite 64