NEC Express5800/320Ma Bedienungsanleitung PDF herunterladen (Seite 103)

Installing the AK533 Kit in an Express5800/320Ma 3.2 GHz System

Installing the AK533 Kit in an Express5800/320Ma 3.2 GHz System A-5

6. Install the dual-PCI cover (number 1 in Figure A-5), as follows:

a. Align the two standoffs on the dual-PCI cover with the holes at the rear of the

enclosure and push the standoffs into the holes (number 2 in Figure A-5).

b. Insert a 4-40 Phillips, 1-inch long screw into the end of each standoff and

tighten the screws. After you install the screws, the dual-PCI cover slides back

and forth, but you should not be able to remove it from the enclosure.

Figure A-5. Installing the Dual-PCI Cover

7. Pull the dual-PCI cover straight back out of the enclosure until it stops.

8. If you have installed only one PCI adapter in the PCI riser assembly, install a blank

PCI faceplate in the open slot of the dual-PCI cover to maintain proper airflow

through the enclosure. Do the following:

a. From the inside of the dual-PCI cover, hook the tab on the faceplate into the

side of the dual-PCI cover that is closest to PCI slot 1 (number 2 in Figure A-6).

b. Secure the other side of the faceplate to the dual-PCI cover by pushing a

plastic rivet into the hole on the faceplate (number 1 in Figure A-6).

NOTE

A spare blank faceplate and/or support clip can be stored

to the side of PCI slots 2 and 3 (Figure A-7). Secure the

parts to the enclosure frame with plastic push-top

replaceable rivets.

1 Dual-PCI cover

2 Screws on standoffs

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 109 110

Keine Kommentare

NEC Express5800/320Ma Bedienungsanleitung Seite 103