NEC Express5800/GT110d-S Installationsanleitung PDF herunterladen (Seite 61)

3. Setting Up Windows Server 2008 R2

Chapter 1 Installing Windows

3.5.3

Setting up team/LiveLink

Important

 You must set up LiveLink when setting up a team. Teams that are not

configured for LiveLink are not supported.

 When deleting the team, refer to Chapter 1 (3.5.3 Setting up team/LiveLink)

– (4) Procedure for deleting team. When replacing the motherboard or a

LAN board, follow these steps to remove the team and then create it again

after replacement.

 Be sure to specify the same Jumbo Mtu (Jumbo Packet) setting to all the

adapters that compose a team.

(1) Team types

The following team types are supported.

 Smart Load Balancing and Failover (without Standby Member)

All adapters that compose the team perform communication.

If a communication failure occurs on an adapter, other adapters that compose the team continue the

communication.

When the adapter on which the communication failure occurred recovers, it joins the team again and

resumes the communication.

 Smart Load Balancing (Auto-Failback Disable) (with Standby Member)

Among the adapters that compose the team, primary adapters except the standby member perform

communication.

If a communication failure occurs, the standby member continues the communication.

When the adapter on which the communication failure occurred recovers, it joints the team again and

the standby adapter returns to the standby state.

(2) LiveLink

Live

Link is a function that detects communication route failures of adapters.

It periodically investigates the communication status of specified destinations (IP address).

Link packets are sent from each adapter within a team.

If a response to the transmission of a link packet within the specified range is not detected, it is identified as a

communication route failure and adapter communication is stopped.

When a response to the submission of a link packet is detected, communication LiveLink identifies

communication as having been recovered, and communication using that adapter automatically resumes.

Important

You must set up LiveLink when you create a team.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 277 278

Keine Kommentare

NEC Express5800/GT110d-S Installationsanleitung Seite 61