NEC Express5800/GT110d-S Installationsanleitung PDF herunterladen (Seite 253)

7. Setup for Solving Problems

Chapter 1 Installing Windows

9. In the Pagin

g file size for each drive group box, specify as follows:

For the Initial size text box, specify a value equal to or greater than the Recommended value shown in

the Total paging file size for all drives area.

For the Maximum size text box, specify a value equal to or greater than the value specified in the Initial

size text box.

After specifying the above values, click [Set].

Important

 The above paging file sizes are recommended for collecting debug

information (dump file). The initial size of the boot volume paging file must

be large enough to store dump files. Make sure to set a sufficient paging

file size. If the paging file size is insufficient, correct debug information

might not be able to be collected due to a shortage of virtual memory.

 For details about the Recommended value in the Total paging file size for

all drives area, refer to System partition size in Before Starting Setup.

 When memory is added, re-specify the paging file according to the

increased memory size.

10. Click [OK].

A message to restart the system might appear, depending on the modifications made.

In this case, restart the system.

Specification of the memory dump settings is now complete.

Express5800/GT-110d, GT-110d-S, R110d-1E, E110d-1 Installation Guide (Windows)

253

1 2 ... 248 249 250 251 252 253 254 255 256 257 258 ... 277 278

Keine Kommentare

NEC Express5800/GT110d-S Installationsanleitung Seite 253