NEC Express5800/GT110b Betriebsanweisung PDF herunterladen (Seite 47)

General Description 2-17

POST Execution Flow

The following describes the progress of POST in the chronological order.

IMPORTANT:

 Do not power off the server while POST is in progress.

 Do not make key entries or perform mouse operations while POST

is in progress.

 Some system configurations may display the message "Press Any

Key" to prompt a key entry. This message is driven by BIOS of an

installed optional board. Make sure to read the manual that comes

with the optional board before any key entry.

 Powering on the server, after you installed or removed an optional

PCI board or moved it to another slot, may display the message that

indicates incorrect board configuration and suspend POST.

In such a case, press F1 to continue POST. Board configuration can

be made using the utility described later.

1. After a few seconds from power-on, POST starts checking the memory. The count

message of the basic and expansion memory appears at top left on the display unit screen.

The memory check may take a few minutes to complete depending on the memory size of

the server. Also, it may take approximately one minute for the screen display to appear

after rebooting the server.

2. Some messages appear upon completion of the memory check. These messages appear to

indicate that the system has detected the CPU, keyboard, and mouse.

3. After a few seconds, the following message appears at the bottom left of the screen

prompting you to launch the SETUP utility stored in the BIOS chip on the motherboard.

To launch the SETUP utility, press F2 while the above message is displayed.

Message displayed when the NEC logo appears:

Press <F2> to enter SETUP or Press <F12> to Network

Message displayed when the POST screen appears:

Press <F2> to enter SETUP <F10> Boot menu <F12> to boot from

Network

Launch the SETUP utility only when you need to change the settings to meet the

requirements of the server environment. As long as the above message is not accompanied

by an error message, you do not have to change the settings. (Ignore the message. POST

will continue a few seconds later.)

See Chapter 4 for setup and parameters.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 493 494

Keine Kommentare

NEC Express5800/GT110b Betriebsanweisung Seite 47