NEC Express5800/R120d-2M Installationsanleitung PDF herunterladen (Seite 203)

6. Setting Up Windows Server 2003

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

203

Chapter 1 Installing Windows

6.2

Setup with EXPRESSBUILDER

This section describes how to install Windows with EXPRESSBUILDER.

This feature automatically recognizes the RAID Controller connected to the server and configures the RAID

System, so you must complete the hardware installation of the server by following "User’s Guide ".

Important

• Setup with EXPRESSBUILDER may delete all data in the hard disk drive

depending on the settings. Pay attention to input parameters. You must

be especially careful when configuring the following:

−

RAID settings wizard

−

Partition Settings in the Windows Setup wizard

Backing up user data, as needed, is recommended.

• Before starting setup, be sure to disconnect hard disk drives from the

RAID Controller that is not to be setup. Install those hard disk drives after

setup

has completed. Conducting setup with hard disk drives being

connected with RAID Controller may cause existing data to be erased

unintentionally. It is recommended to make backup copy of user data

before starting setup.

Tips

• Setup with EXPRESSBUILDER allows you to use a prespecified parameter file

or save the parameters specified in setup as a parameter file on a removable

media or Internal Flash Memory (if purchased optionally).

• For details on creating a parameter file, refer to Chapter 1 (8 Windows OS

Parameter File).

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 290 291

Keine Kommentare

NEC Express5800/R120d-2M Installationsanleitung Seite 203