NEC Express5800/R120d-2M Installationsanleitung PDF herunterladen (Seite 200)

6. Setting Up Windows Server 2003

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

200

Chapter 1 Installing Windows

Setting Up Windows Server 2003

Set up Windows Server 2003 and the system.

6.1

Before Starting Setup

Read through the cautions explained here before starting setup.

: Confirm during Setup with EXPRESSBUILDER

: Confirm during Setup with OS standard installer

(1/3)

Setup Items to confirm

Windows

family

The following editions of the Windows Server 2003 family may be installed.

• Windows Server 2003 R2 Standard Edition

• Windows Server 2003 R2 Enterprise Edition

Inquiries about installing other edi

tions may be made at your sales dealer or

maintenance service company. For information about Service Packs, refer to 1.3

Service Pack Support.

Note

Setup with EXPRESSBUILDER cannot be used.

License

authentication

If Windows Server 2

003 is installed from a backup CD, the license is already

activated. If Windows Server 2003 is installed from an OS CD instead of a backup

CD, a product key is required for license authentication. At this time, the product

key must be the same as that indicated on the COA label of Windows Server 2003.

For details, refer to Chapter 1 (6.7 License Authentication).

Important

Activate within 30 days following installation. The system might be

locked if 30 days have passed without activation.

Hardware

configuration

The following hardware configurations require special procedures.

•

When using OEM drivers, be sure to change the boot order of the Flash FDD

on the BIOS settings as follows:

Select Boot, Floppy Drive BBS priorities, Boot Option #1, and then specify

the Flash FDD used.

Note

Change as instructed in Chapter 1 (6.2.3 Setup procedure).

•

Notes on using N8103-149/150/151 on Windows2003:

1) When a battery is used:

The following message may appear on POST screen at reboot if Service

Pack2 is not yet applied. It is not the problem.

cache data recovered successfully

2) When no battery is used:

Set the cache mode of RAID Controller to the default setting (AutoSwitch

or WriteThrough) until Service Pack 2 is applied.

- To operate the RAID Controller in WriteBack

mode, change setting to

WriteBack after Service Pack 2 is applied.

* The default cache mode of RAID Controller is AutoSwitch. It will not change

to WriteBack mode unless it is changed manually at or after creation of VD.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 290 291

Kommentare zu diesen Handbüchern

Keine Kommentare

NEC Express5800/R120d-2M Installationsanleitung Seite 200

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software NEC Express5800/R120d-2M