
5. Setting Up Windows Server 2003 R2 x64 Edition
Express5800/R120d-1M, R120d-2M Installation Guide (Windows)
Chapter 1 Installing Windows
5.7
Installation When Multiple Logical Drives Exist
Before starting installation, backup data for future use in case of data loss.
(1) Installation process
1. Follow the steps to start installation with OS standard installer.
2. When the following message appears, select the partition to which you want to set up the operating
system.
The following list shows the existing partitions and
unpartitioned space on this computer.
Use the UP and DOWN ARROW keys to select an item in the
Important
You cannot edit the drive letters for the system volume or boot volume after
setup is complete. Make sure that the drive letters assigned in this window
are correct, and then proceed with setup.
3. Follow the steps to proceed with installation with OS standard installer.
Tips
The drive letter might change after installation.
If you want to change the drive
letter, use the procedure shown in Changing drive letter assignments below.
(2) Changing drive letter assignments
To change the drive letter, follow the steps below. But these steps cannot change drive letter assignments for
the system volume or boot volume. If you want to change them, re-install the Windows.
1. From the Start menu, right-click My Computer and then select Management. Next, launch Computer
Management.
2. From the window on the left, select Disk Management.
3. Right-click the volume whose drive letter you want to change, and then select Change drive letter and
path.
4. Click [Change].
5. Click [Assign next drive letter], and then select the drive letter you want to assign.
6. Click [OK].
7. When the following message appears, read the contents and then click [OK].
Changing the drive letter of a volume might cause programs
to no longer run. Are you sure you want to change this drive
8. Close the Computer Management window.
Kommentare zu diesen Handbüchern