NEC Express5800/R120d-2M Installationsanleitung PDF herunterladen (Seite 12)

1. Before Starting Setup

Express5800/R120d-1M, R120d-2M Installation Guide (Windows)

Chapter 1 Installing Windows

Before Starting Setup

This section describes the points of using EXPRESSBUILDER (contained in this product) to set up Windows

operating systems.

Important

If you have purchased your server by BTO and ordered to install Windows,

a COA (Certificate of Authenticity) label that describes your product key is

stuck on your server.

The product key is required when setting up or re-installing the OS. Do not

intentionally peel off or damage the label. The product key cannot be

reissued in any occasion. It is recommended to take a note of product key

and store it carefully with other accessories.

1.1

Starting EXPRESSBUILDER

Use the attached EXPRESSBUILDER to reconfigure the RAID System or re-install the OS.

Start EXPRESSBUILDER by either of the following two ways according to the media in which the

EXPRESSBUILDER is stored. Refer to Chapter 2 (5. Details of EXPRESSBUILDER) in the Maintenance

Guide for more information.

With the pre-installation model, you do not need to start the EXPRESSBUILDER.

EXPRESSBUILDER DVD

Insert the DVD to the optical disk drive of the server, and then reboot by turning off and on the server or by

pressing <Ctrl> + <Alt> + <Delete> keys.

Internal Flash Memory (optional)

Press <F3> key when the following message appears on POST screen. At this time, be sure to remove a

bootable disc from the optical disk drive.

Press <F2> SETUP, <F3> Internal Flash Memory, <F4> ROM Utility, <F12> Network

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 290 291

Keine Kommentare

NEC Express5800/R120d-2M Installationsanleitung Seite 12