NEC Express5800/R110d-1E Betriebsanweisung PDF herunterladen (Seite 83)

Setting Rebuild Priority

You can set the priority at which Rebuild is executed in the computer. The procedure of setting the Rebuild

Priority is described below.

Setting Rebuild Priority are available only in the Advanced Mode.

RAID Viewer

Change the property of RAID Controller.

Step 1

Start the RAID Viewer. Click the RAID Controller on the Tree View. Then click [Properties] on the pull-down

menu of menu item [File].

Step 2 Click the [Options] tab in the [RAID

Controller Properties] dialog box. Change the value of

[Rebuild Priority] to [High], [Middle], or [Low]. Click

[OK] or [Apply].

raidcmd

Use "optctrl" command.

Step 1 Execute "optctrl" command with -rp option

and the defined parameters.

-c : Number of the RAID Controller for which Rebuild

Priority is set

-rp : Value set after Rebuild Priority is set(Select a value

out of High, Middle, and Low)

Step 2 Check the execution result by using

property" command.

> raidcmd optctrl -c=1 -rp=Middle

> raidcmd property -tg=rc -c=1

RAID Controller #1

ID : 0

Vendor : LSI Corporation

Model : MegaRAID SAS PCI Express(TM)

ROMB

Firmware Version : 1.12.02-0342

Cache Size : 128MB

Battery Status : Normal

Rebuild Priority : Middle

Consistency Check Priority : Low

Patrol Read : Enable

Patrol Read Priority : Low

Buzzer Setting : Enable

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 105 106

Keine Kommentare

NEC Express5800/R110d-1E Betriebsanweisung Seite 83