NEC Express5800/R120a-1 Bedienungsanleitung PDF herunterladen (Seite 63)

Step 4 After the Logical Drive is created completely, the raidcmd terminates normally. The Logical Drive has been

the Logical Drive by using "property" command. However, the

ot be completed. The progress and result of initializing the

and.

"Create Logical Drive - Simple

created completely. You can check the information on

Initialize of the Logical Drive having been created may n

Logical Drive can be checked by using "oplist" comm

Physical Devices Available for

Mode"

Unused P

those

hysical Devices are available for "Create Logical Drive - Simple Mode". Unused Physical Devices are

with their [Status] being [Ready].

Physical Devices in which S.M.A.R.T. errors are detected cannot be used to create Logical

Drives.

reate Logical Drive - Simple

Mode"

Creating Logical Drives by "C

This s

RAID Level

ection describes the information on Logical Drives to be created by "Create Logical Drive - Simple Mode".

The RAID Level of a Logical Drive which can be created by "Create Logical Drive - Simple Mode" should be

RAID 1 or RAID 5.

Capacity of Logical Drive

The capacity of a Logical Drive to be created

Devices used for the Logical Drive. In "Create Lo

using the entire areas of the Physical Devices.

Items set for Logical Drive

is defined by the RAID Level and the capacities of Physical

gical Drive - Simple Mode", a Logical Drive is created by

The values of other selection items set for a Logic

below.

al Drive to be created are defined as shown in the table

Selection item Value

Stripe Size Uses the default value set for the RAID Controller. (The value varies depending on the

type of the RAID Controller.)

Cache Mode Uses the default value set for the RAID Controller. (The value varies depending on the

type of the RAID Controller.)

ode Full Initialization M

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 117 118

Keine Kommentare

NEC Express5800/R120a-1 Bedienungsanleitung Seite 63