NEC Express5800/R120a-1 Bedienungsanleitung PDF herunterladen (Seite 23)

Starting or Stopping Universal RAID

Utility

This chapter describes the procedure of starting or stopping each module in the Universal RAID Utility.

raidsrv service

The raidsrv service is started automatically when your computer is booted and stopped automatically when your

computer is shut down.

Without operation of the raidsrv service, the Universal RAID Utility cannot operate normally. Neither make the raidsrv

service be not started nor stop the raidsrv service.

In case of the operating system is Linux or VMware ESX Server, if the raidsrv service

terminates abnormally due to occurrence of an error or a process of the raidsrv service is

terminated forcibly, the lock file for avoiding double starts is left. If the state remains, the

raidsrv service may not be started.

If this occurs, delete the following file before restarting the raidsrv service:

/var/lock/subsys/raidsrv

Starting Universal RAID Utility in Single User Mode

The Universal RAID Utility uses network functions. Accordingly, the Universal RAID Utility cannot be used in the

single user mode of Linux and VMware ESX Server without network functions. To use the Universal RAID Utility

in the single user mode, first enable the network functions in the following procedure and start the raidsrv

service.

raidsrv (pid 3738 3718) is running...

> /etc/init.d/raidsrv status

> /etc/init.d/raidsrv start

> /etc/init.d/network start

Step 1

Start the network service.

Step 2 Start the raidsrv service.

Step 3 Check that the raidsrv service is started normally.

If a process ID appears, the raidsrv service is started

normally.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 117 118

Keine Kommentare

NEC Express5800/R120a-1 Bedienungsanleitung Seite 23