NEC Express5800/R110d-1E Installationsanleitung PDF herunterladen (Seite 33)

NEC ESMPRO Manager Ver.5 Installation Guide (Linux)

4.1.5.5 In Case of Key-in Failure on the Remote Console

-- During DOS boot or access to the FD or CD-ROM drive immediately after the managed component’s

power switch is turned ON, data cannot be keyed in from the remote console or the keyed data display

may be delayed.

-- Remote Console is realized by using the Serial Over LAN (SOL) function of the IPMI conformity and the

Serial Redirection function of BIOS. Data cannot be keyed in from the Remote Console when the

firmware(BIOS and so on) or the software requires the key code that VT100 terminal emulator (the

hyper-terminal and so on) can't control. Refer to the manual of each firmware or software for the details.

4.1.6 Power Management

-- The power value which NEC ESMPRO Manager reads from the managed component has about +/-10%

margin of error.

-- The electric power value might not necessarily reach even the value of Power Cap value. The electric

power control lowers the power consumption of the system by lowering the frequency of CPU/Memory.

When CPU/Memory Throttling value reaches 100%, the electric power value doesn't fall any more.

4.1.7 About CPU blade auto registration

-- When “Check Connection” of “CPU blade auto registration” was failed.

Retry of “CPU Blade auto registration” is not necessary. You can execute “Check Connection” on “Server

Setting” – “Connection Setting”. If a specified IP address is set from a CPU blade to another CPU blade

during “CPU blade auto registration” process (ex. when you replace CPU blade and execute “CPU blade

auto registration”), NEC ESMPRO Manager may not be able to connect the CPU blade because old

information remains in the ARP table on the management PC. Wait for a few minutes and try the “Check

Connection”.

4.1.8 About the coexistence of NEC ESMPRO Manager with DianaScope

Agent or NEC ESMPRO Anget Extension on the same component

If the managed component is installed Advanced Remote Management Card or EXPRESSSCOPE Engine

series (the BMC uses Management LAN port), NEC ESMPRO Manager can manage the component itself

installed.

It the managed component is installed BMC that uses the standard LAN port, NEC ESMPRO Manager

cannot manage the component itself installed. It is possible only to install NEC ESMPRO Manager and

DianaScope Agent or NEC ESMPRO Agent Extension on the same component. But the communication with

BMC on the component is prevented by local loopback function of OS and the BMC cannot receive any

packets from the NEC ESMPRO Manager.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 42 43

Keine Kommentare

NEC Express5800/R110d-1E Installationsanleitung Seite 33