NEC Express5800/120Bb-6 Betriebsanweisung PDF herunterladen (Seite 134)

114

4-2 Manual Rebuild

Described below is the rebuild procedure when one of the HDD fails in a RAID1 virtual disk configured with

two HDD‟s.Replace the failed HDD with a new one after turning off the power of the server. The Auto Rebuild

feature is disabled for non-hot-swap replacement. Use the Manual Rebuild feature to recover the virtual disk

as described below:

1. Start WebBIOS.

Make sure that the status for the replaced HDD is indicated as "UNCONF GOOD" in the right frame

of the top menu.

2. Make sure that the HDD that has been installed in slot 1 is missing.

3. Select "PD2" (newly connected HDD) in [Physical Drives].

The properties for the physical drive are displayed.

4. Select "Make Global HSP" from the lower right of the screen, and then click [Go] at the lower center

of the screen.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 145 146

Keine Kommentare

NEC Express5800/120Bb-6 Betriebsanweisung Seite 134