NEC Express5800/R110f-1E Einstellungsanleitung PDF herunterladen (Seite 98)

NEC ESMPRO Manager Setup Guide

management LAN port for the Master BMC to the form.

Subnet Mask1 Enter the subnet mask that is specified on LAN1 of the BMC

configuration for the managed component.

If the managed component is a fault tolerant server, you should enter the

subnet mask of the management LAN port for the CPU/IO module 0 to

the form.

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the subnet mask of the

management LAN port for the Master BMC to the form.

IP Address 2 Enter the IP address that is specified on LAN2 of the BMC configuration

for the managed component.

If the managed component is a fault tolerant server, you should enter the

IP address of the management LAN port for the CPU/IO module 1 to the

form.

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the IP address of the

management LAN port for the Standby BMC to the form.

Subnet Mask1 Enter the subnet mask that is specified on LAN2 of the BMC

configuration for the managed component.

If the managed component is a fault tolerant server, you should enter the

subnet mask of the management LAN port for the CPU/IO module 1 to

the form.

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the subnet mask of the

management LAN port for the Standby BMC to the form.

CHECK:

・*1 If a self-signed certificate is installed on the managed server for HTTPS

communication, a setting to allow it is required. Refer to “1.1 Setup Flow” for

detailed information.

CHECK:

・*2 Regarding a port number for WS-Man communication, refer to “Appendix C. Port

number for WS-Man communication”.

IMPORTANT:

・If BMC(EXPRESSSCOPE Engine) management is disabled, NEC ESMPRO Manager

connot monitor HW status. Detailed information is shown in the connection check

result screen.

(4) Click “Add”.

(5)Click the “Connection Setting” from “Setting” tab of the managed component.

.Click “Check Connection” to collect the VMware ESXi5 server information for the management

When the “Check Connection” is completed, the NEC ESMPRO Manager starts to control the VMware

ESXi5 server

Detected Detail

Detected The feature was detected.

NEC ESMPRO Manager can use the feature to manage the component.

Not Detected The feature was not detected.

NEC ESMPRO Manager cannot use the feature to manage the component.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 124 125

Kommentare zu diesen Handbüchern

Keine Kommentare

NEC Express5800/R110f-1E Einstellungsanleitung Seite 98

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Gateways / Controller NEC Express5800/R110f-1E