NEC NP-PH1400U Bedienungsanleitung PDF herunterladen (Seite 30)

2. Projecting an Image (Basic Operation)

Using the Power Cord Stopper

TopreventthepowercordfromaccidentlyremovingfromtheACINoftheprojector,attachthepowercordstopper

toclampthepowercord.

NOTE:

• Donotclampthepowercordwithothercables.Doingsocangeneratenoise,whichcanaffectadverselythesignalcable.

CAUTION

• Donotbundlethepowercord.Doingthiscouldcauseheatorare.

• Donotclamptwopowercordsthatwouldbeusedwhenstackingtwoprojectors.Doingthiscouldcausea

re.

NOTE:Becarefulnottoinsertthebandinversely.Oncethebandisattached,itcannotberemovedfromtheslot.

Attaching the power cord stopper

1. InserttheendofbandofthepowercordstopperintotheslotnexttotheACINontheterminalpanel.

2. Use the power cord stopper to clamp the power cord.

 Pushtheclampertolockit.

Clamper

3. Slidetheclampertothehiltofthepowercord.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 254 255

Keine Kommentare

NEC NP-PH1400U Bedienungsanleitung Seite 30