NEC Express5800/R110f-1E Installationsanleitung PDF herunterladen (Seite 18)

dd "mode" and "primary" definition to the line

If the teaming is set with channel bonding on Linux, please a

of /etc/modprobe.conf or /etc/modules.conf as following.

options bondname mode=1 primary=eth0 miimon=100



 Setting of Teaming for LAN that DianaScope Agent or NEC ESMPRO Agent Ext

(providing r

installed BMC that uses a Management LAN port

ension uses with OS

edundancy or multiplexing with multiple network adapters) on the managed server

managed server

es a Management LAN port, see "Appendix B B.2 On the managed server that BMC

e".

of the hardware of a default gateway or an alert receiver

, re-configure BMC on

ere is not gateway

een an alert receiver and a managed server, re-configure BMC on the managed server after the

ow MAC address of the new

are by setting BMC configuration.

ow any authentication

properties.

ng another device in

Serial over LAN (SOL) and set enable on following BMC

AN/Direct)"

set in BMC configuration information. (Even if NEC ESMPRO Manager

M2).)

If the teaming setting is made available for LAN port that DianaScope Agent uses on the

installed BMC that us

uses a Management LAN port" in "NEC ESMPRO Manager Ver.6 Setup Guid

 Change

In case that there is a gateway between a PC for Management and a managed server

the managed server after the change the hardware of the gateway. In case that th

betw

change the hardware of the alert receiver. BMC on the managed server can kn

hardw

 Use of a dialup router or a PPP server

If an alert receiver via modem uses Windows Remote Access Service, select "All

including clear text" about the encryption on the Windows Remote Access Service

 Restrictions on use of the standard serial port 2 (COM2)

The standard serial port 2 (COM2) on a managed server cannot be used for connecti

the following cases because BMC occupies the serial port 2.

- The managed server compatible with

Configuration items:

"Remote control (W

"Redirection (LAN)"

"Redirection (WAN/Direct)"

- Connection via modem or direct connection has been made.

- Direct connection has been

and managed server are not connected, BMC occupies the serial port 2 (CO

Note See "Appendix D Managed Components Summary" in "NEC ESMPRO Manager Ver.6 Setup

Guide" to confirm whether that your server supports SOL.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 49 50

Kommentare zu diesen Handbüchern

Keine Kommentare

NEC Express5800/R110f-1E Installationsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Server NEC Express5800/R110f-1E