NEC MDview 213 Betriebsanweisung PDF herunterladen (Seite 9)

English

English-7

Figure S.1

4. Place one hand around the base and one hand on the Quick Release Lever. Move the Quick Release Lever in the direction

indicated by the arrows (Figure S.2).

5. Lift up the bottom of the stand to unhook it from the monitor (Figure S.3). The monitor can now be mounted using and

alternate method. Reverse process to reattach stand.

NOTE: Handle with care when removing monitor stand.

Figure S.2

Flexible Arm Installation

This LCD monitor is designed for use with a flexible arm.

1. Follow the instructions on how Remove Monitor Stand for

Mounting to remove the stand.

2. Using the 4 screws from the stand removal and attach the arm to

the monitor (Figure F.1).

Caution: Use ONLY the screws (4 pcs) that are included when

mounting to avoid damage to the monitor and stand.

To fulfil the safety requirements the monitor must be

mounted to an arm which guaranties the necessary

stability under consideration of the weight of the monitor.

The LCD monitor should only be used with an approved

arm (e.g. GS mark).

When using mounting accessories (e.g. VESA (200 x 100))

other than VESA (100 x 100), use the screws M4 size

(Length: bracket thickness + 10mm).

Figure S.3

Remove Monitor Stand for Mounting

To prepare the monitor for alternate mounting purposes:

1. Disconnect all cables.

2. Place hands on each side of the monitor and lift up to the highest position.

3. Place monitor face down on a non-abrasive surface (Figure S.1).

100mm

Figure F.1

Slide

200mm

NEC MDview 242/242-2 and 262/262-2 Only!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 32 33

Keine Kommentare

NEC MDview 213 Betriebsanweisung Seite 9