NEC E463 Bedienungsanleitung PDF herunterladen (Seite 16)

English-15English-14

Battery Installation and Replacement

The remote control is powered by two 1�5V AAA batteries� To install or replace batteries:

1� Open the battery cover of the remote control by pushing and pulling it in

the direction of the arrow�

2� Insert two new “AAA” size batteries for the remote control� When replacing

old batteries, push them towards the springs and lift them out�

3� Match the batteries to the (+) and (-) marks in the battery compartment�

4� Insert the bottom of the battery, the (-) side, into the battery compartment

rst, push towards the springs and insert the top of the battery, the (+)

side, into place� Do not force the battery into the battery compartment�

5� Close the battery cover making sure the tabs rest in the corresponding

holes and push down the cover until it clicks shut�

CAUTION: Incorrect usage of batteries can result in leaks or bursting�

NEC recommends the following battery use:

• Do not mix battery brands�

• Danger of explosion if battery is

incorrectly replaced� Replace only

with the same or equivalent type�

• Do not combine new and old

batteries� This can shorten the

battery life or cause liquid leakage

of the batteries�

• Remove dead batteries

immediately to prevent battery

acid from leaking into the battery

compartment�

• Do not touch exposed battery acid

as it may injure skin�

• Remove the batteries if you do not

intend to use the remote control for a long period of time�

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Keine Kommentare

NEC E463 Bedienungsanleitung Seite 16