NEC EU1V0UM00 Bedienungsanleitung

Quick Startup Guide Low-Voltage Starter Kit For Motor Control Document No. UxxxxxEU1V0UM00 ©2006 April. NE

Motor Control I/O Board User’s Manual To control the motor from a GUI on your PC, connect a serial cable to the J9 RS-232 port on the MC-IO board

Motor Control I/O Board User’s Manual condition is displayed on the seven-segment LED. For details on the protection functions implemented in hard

Motor Control I/O Board User’s Manual Figure 7. Motor Control Software and Documents Installation GUI 4. Install all of the software in the fo

Motor Control I/O Board User’s Manual 2. Remove jumpers JP5 2-5, JP5 3-6 and 2JP7 1-2 and reconnect M-78F0714 to MC-IO board. 7

Motor Control I/O Board User’s Manual Figure 9. Jumpers for Standalone Operation Figure 10. Debugging Setup 3. Attach the on-chip debuggi

Motor Control I/O Board User’s Manual Figure 11. Debugging Environment Shown with QB-78K0MINI On-Chip Debugger Note: The on-chip debugger has a

Motor Control I/O Board User’s Manual Figure 12. PM Plus Workspace 4. Click File and select Open Workspace. 5. Browse to C:\NECTools32\ \Motor

Motor Control I/O Board User’s Manual through the on-chip debugging emulator and the source code displayed in the Debugger window as shown below.

Motor Control I/O Board User’s Manual 10. GUI Operation To operate the motor from the PC GUI, the code has to be rebuilt with “GUI” option. Select

Motor Control I/O Board User’s Manual The GUI will launch if the connection is established: Figure 17. BLDCM GUI 2. To operate the motor, use

Motor Control I/O Board User’s Manual ii The information in this document is current as o

Motor Control I/O Board User’s Manual iii

Motor Control I/O Board User’s Manual iv Revision History Date Revision Section Description 04-2006 — — First release

Motor Control I/O Board User’s Manual Contents 1. Introduction...

Motor Control I/O Board User’s Manual 1. Introduction The low-voltage starter kit for motor control (MC-LVKIT-714) is a complete 3-phase motor co

Motor Control I/O Board User’s Manual For the instruction descriptions, refer to the 78K/0 Series Instruction User’s Manual (U12326E) 3. Hardware

Motor Control I/O Board User’s Manual Figure 3. Motor Phase Connections Figure 4. Hall Sensor Connections The software to run the motor is