NEC Express5800/GT110e-S Installationsanleitung PDF herunterladen (Seite 82)

3. Setting Up Windows Server 2008 R2

press5800/GT-110e, GT-110e-S, R110e-1E Installation Guide (Windows)

Chapter 1 Installing Windows

3.9

Installation When Multiple Logical Drives Exist

Before starting installation, backup data for future use in case of data loss.

(1) Installation process

− Setup with EXPRESSBUILDER

Important

Before starting setup, be sure to disconnect hard disk drives from the RAID

Controller that is not to be setup. Install those hard disk drives after setup

has completed. Conducting setup with hard disk drives being connected

with RAID Controller may cause existing data to be erased unintentionally.

Refer to Chapter 1 (3.2 Setup with EXPRESSBUILDER), and proceed with setup.

In this case, EXPRESSBUILDER installs the Windows on the first detected hard disk drive or logical drive.

− Setup with OS standard installer

1. Refer to Chapter 1 (3.3 Setup with OS Standard Installer), and start setup.

2. When the following message appears, select the partition to which you want to install the operating

system.

Select the location to which Windows will be installed

The order and numbers of the disks displayed on the screen might not match the server’s slot

of the

hard disk drives. Distinguish between the hard disk drives by viewing the hard disk drive

capacity and partition size displayed on the screen, and then select a drive to install the Windows

system.

Selecting an improper drive might cause an unintentional corruption of the existing data. Be careful

when selecting a hard disk drive on which to install the system.

Important

• For details, refer to the following Microsoft website:

http://support.microsoft.com/kb/937251/en-us

•

You cannot edit the drive letters for the system volume or boot volume

after setup is complete. Make sure that the drive letters assigned in this

window are correct, and then proceed with setup.

3. Refer to Chapter 1 (3.3 Setup with OS Standard Installer), and proceed to setup Windows with OS

standard installer and the instructions.

Tips

The drive letter might change after installation.

If you want to change the drive

letter, use the procedure shown in Changing drive letter assignments below.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 274 275

Keine Kommentare

NEC Express5800/GT110e-S Installationsanleitung Seite 82