Nec LT180 Bedienungsanleitung PDF herunterladen (Seite 21)

E-14

PC CONTROL

COMPONENT IN

COMPUTER IN

VIDEO INAUDIO IN

S-VIDEO IN

Cr/Pr

Cb/Pb

AUDIO IN

AC IN

MONITOR OUT

COMPUTER IN

AUDIO OUT

AUDIO IN

PHONE

Audio cable (not supplied)

IBM VGA or Compatibles (Notebook type)

or Macintosh (Notebook type)

IBM PC or Compatibles (Desktop type)

or Macintosh (Desktop type)

RGB/VGA signal cable (supplied)

To mini D-Sub 15-pin connector on the projector. It

is recommended that you use a commercially avail-

able distribution amplifier if connecting a signal

cable longer than the one supplied.

NOTE: For older Macintosh, use a com-

mercially available pin adapter (not sup-

plied) to connect to your Mac's video port.

Connecting your PC or Macintosh computer to your projector will enable you to project your computer's screen

image for an impressive presentation.

To connect to a PC or Macintosh, simply:

1. Turn off the power to your projector and computer.

2. Use the supplied RGB/VGA signal cable to connect your PC or Macintosh to the projector.

3. Turn on the projector and the computer.

4. If the projector goes blank after a period of inactivity, it may be caused by a screen saver installed on the

computer you've connected to the projector.

2. INSTALLATION AND CONNECTIONS

NOTE: When using with a notebook PC, be sure to connect between the projector and the notebook PC before turning on the

power to the notebook PC. In most cases signal cannot be output from RGB output unless the notebook PC is turned on after

connecting with the projector.

* If the screen goes blank while using your remote control, it may be the result of the computer's screen-saver or power

management software.

Making Connections

Connecting Your PC or Macintosh Computer

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 72 73

Kommentare zu diesen Handbüchern

Keine Kommentare

Nec LT180 Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Projektoren Nec LT180