Nec ExpressA1160 Bedienungsanleitung PDF herunterladen (Seite 87)

Section 4

EXPRESSSCOPE® Monitor Interface

This section describes the EXPRESSSCOPE® Monitor interface. EXPRESSSCOPE®

Monitor functionality is a subset of management firmware functionality, offering menus

with limited options to configure, control, and monitor the Express5800/A1160 system

components. Different menus apply to partitions, cells, and the system as a whole.

Refer to 2.2 EXPRESSSCOPE® Monitor Interface

for uses of and instructions on

accessing the EXPRESSSCOPE® Monitor interface.

4.1. Components

To operate the EXPRESSSCOPE® Monitor interface components, you may need to

detach the bezel from the front of the Cell (refer to 11.5 Front Bezel).

Figure 4-1

shows the EXPRESSSCOPE® Monitor interface components that appear on

the front of each cell, as follows:

• An LCD that displays information about the system, partition, and cell; and

information that is accessed using a menu system (refer to 4.1.1 Main Screen

Display and 4.1.5 EXPRESSSCOPE® Monitor LCD Back Light)

• Operational buttons for navigating in the menu system, for applying and removing

DC power to the cell, and for identifying the cell chassis (refer to 4.1.2 Operational

Buttons)

• Two LEDs that indicate the cell operating status and communication faults with

management firmware on the Service Processor (refer to 4.1.4 EXPRESSSCOPE®

Monitor LEDs)

Notes:

• Applying DC power to a cell applies power to all cells in the partition containing the

cell that are not already powered on and might boot the partition, depending on

settings.

• Using the EXPRESSSCOPE® Monitor power button is usually for maintenance

purposes only; the remote console interface is the preferred method for applying

and removing DC power.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 251 252

Keine Kommentare

Nec ExpressA1160 Bedienungsanleitung Seite 87