NEC NP100 Bedienungsanleitung

Portable ProjectorNP200/NP100User’s Manual

4English ...IntroductionProduct Features This product is an SVGA/XGA single chip 0.55” DLPTM pro-jector. Outstanding features include: NP100: True

5... EnglishIntroductionPower CableUS (P/N:79TC1031)EU (P/N: 79TC1041)CH (P/N: 79TC1051)VGA Cable(P/N : 79TC1001)Wireless Remote Control(P/N:79TC1021)

6English ...Introduction1. Power 2. Remote Control3. Power (LED indicator)4. Zoom and Focus Rings5. Speaker6. Lens7. Lens Cap8. Ventilation

7... EnglishIntroductionConnection Ports1. COMPUTER IN Connector2. S-VIDEO IN Connector3. VIDEO IN Connector4. SERVICE Port5. MONITOR OUT Connect

8English ...IntroductionWireless Remote Control1Power Refer to the “Power On/Off the Projector” section on pages 12-13.2 Picture Mode Select the Pictu

9... EnglishIntroduction5 Keystone CorrectionAdjust the image to compensate for distortion caused by tilt-ing the projector (vertical ± 40 degrees).6

10English ...IntroductionBattery InstallationRemote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it

11... EnglishInstallationConnecting the ProjectorDue to the differ-ence in applications for each country, some regions may have differ-ent accessori

12English ...InstallationPowering On the Projector1. Ensure that the power cable and signal cable are securely connected. The Power LED will ash blu

13... EnglishInstallationPowering Off the Projector1. Press the “Power” to turn off the projector lamp, you will see a message as below on the on-s

© NEC Display Solutions, Ltd. 2007First edition December 2007• DLP and BrilliantColor are trademarks of Texas Instruments.• IBM is a trademark or regi

14English ...InstallationWarning Indicator When the “Power” LED indicator turns red, it indicates the projector has overheated. The projector will

15... EnglishInstallationAdjusting the Projected ImageAdjusting the Height of Projector ImageThe projector is equipped with adjustable feet to raise a

16English ...InstallationMax. 30.3"(76.9cm) 75.7"(192.3cm) 126.2"(320.5cm) 176.7"(448.7cm) 227.1"(576.9cm) 302.8"(769.2c

17... EnglishUser ControlsThe Projector has a multilingual On Screen Display that allows you to make image adjustments and change a variety of set-tin

18English ...User ControlsImage(PC Mode) Picture Mode There are many factory presets optimized for various types of im-ages. Use the or to selec

19... EnglishUser Controls Clock “Clock” changes the display data frequency to match the frequency of your computer’s graphic card. If you experienc

20English ...User ControlsImage(Video Mode) Picture Mode There are many factory presets optimized for various types of im-ages. Use the or to se

21... EnglishUser Controls Color Adjust a video imge from black and white to fully saturated color.  Press the to decrease the amount of color in

22English ...User ControlsDisplay Setting Keystone Adjust image distortion caused by tilting projector. (±40 degrees). H-Position (Horizontal Posit

23... EnglishUser Controls Orientation  Front-Desktop The factory default setting.  Rear-Desktop When you select this function, the pr

iEnglish ...Important InformationSafety CautionsPrecautionsPlease read this manual carefully before using your NEC NP100/NP200 projector and keep the

24English ...User Controls Source Lock When this function is turned “Off”, the projector will search for other signals if the current input signal i

25... EnglishUser Controls Audio  Mute: Choose “On” to mute the volume. Choose “Off” to restore the volume.  Volume: Press t

26English ...User Controls Language Choose the multilingual OSD. Press into the sub menu and then use the or or or key to select your prefe

27... EnglishUser Controls Information To display the projector information on the screen.Information

28English ...AppendicesProblem: No image appears on screen Ensure all the cables and power connections are correctly and securely connected as descr

29... EnglishAppendices 4. Verify the resolution setting is less than or equal to 1280 x 1024 resolution. 5. Select the “Change” under the “Moni

30English ...AppendicesProblem: Image has vertical ickering bar Use “Clock” to make an adjustment. Check and recongure the display mode of your g

31... EnglishAppendicesSteady light => No light => MessagePower-LED(Blue) (Red) (Purple)Standby (Input power cable)Flashing(0.5 sec.)Power on (W

32English ...AppendicesProblem: Message Reminders Over temperature - the projector has exceeded its recommended operating temperature and must be al

33... EnglishAppendicesReplacing the lamp (optional lamp NP10LP)The projector will detect the lamp life at 3400 hours in Normal mode. When the “Power”

iiEnglish ...Important InformationRF Interference (for USA only)WARNINGThe Federal Communications Commission does not allow any modications or change

34English ...AppendicesWarning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and ca

35... EnglishAppendicesSpecicationsProjection System Single Chip DLPTM Technology by Texas InstrumentsNumber of Pixels* NP100: 800 pixels(H) X 600 li

36English ...AppendicesCompatibility ModesModes ResolutionV.Frequency(Hz) H.Frequency(kHz) VGA 640 x 480 60 31.50640 x 480 72 37.90640 x 480 75 37.506

37... EnglishAppendicesCabinet Dimensions10.7"/272mm3.4"/86mm1.7"/42mm7.8"/199mm3.2"/80mm8.1"/206mmLens Center

Power No power (POWER indicator does not light blue). Power cable’s plug is fully inserted into the wall outlet. Lamp cover is installed cor

In the space below please describe your problem in detail.Information on application and environment where your projector is usedProjectorModel number

TravelCare GuideTravelCare - a service for international travelersThis product is eligible for “TravelCare”, NEC’s unique international warran

Hyosung ITX Co., Ltd.Address: 2nd Fl., Ire B/D. #2, 4Ga, Yangpyeng-Dong, Youngdeungpo-Gu, Seoul, Korea 150-967Telephone: +82 2 2163 4193Fax Line:

TO: NEC or NEC’s Authorized Service Station: FM: (Company & Name with signature) Dear Sir (s), I would like to apply your TravelCare Service Pr

5. Loan Service Charges and Conditions:Upon acceptance of this NEC Projector, Customer agrees to assume liability for this loan unit.The current cost

iiiEnglish ...Important Information Fire and Shock Precautions • Ensure that there is sufcient ventilation and that vents are unobstructed to prev

ivEnglish ...Important Information Remote Control Precautions• Handle the remote control carefully.• If the remote control gets wet, wipe it dry

1... EnglishTable of ContentsTable of Contents ... 1Usage Notice

2English ...Usage NoticePrecautions Follow all warnings, precautions and maintenance as recom-mended in this user’s guide to maximize the life of your

3... EnglishUsage Notice Do: Turn off the product before cleaning. Use a soft cloth moistened with mild detergent to clean the display housing.